We are a specialized Exporter and Supplier of Embedded Trainer Kit (ET-51). Embedded Trainer Kit (ET-51) is an Embedded Trainer for Philips 89V51RD2. This Embedded Trainer Kit (ET-51) come with features like Stepper Motor Controller Interface, LCD Display Interface, 8x8 LED Interface Block, etc.

System Detail

• CPU : Philips 89V51RD2 Microcontroller
• Six Seven Segment Displays
• Stepper Motor Controller Interface
• LCD Display Interface
• 8x8 LED Interface Block
• EWSN Status LED's 12 Nos.
• 8 Chanel ADC Interface
• Four Data Switches
• Relay
• Opto
• Real Time Clock
• Switch Array
• At24C16 Serial EEPROM
• RS-232 Interface using Rx/Tx of MCU for uploading/downloading

Internal Peripheral Features

• On-chip Flash Program Memory with ISP and IAP capability
• Parallel programming with 87C51 compatible hardware
• Supports 6-clock/12-clock mode via parallel programmer
• 6/12-clock mode Flash bit erasable and programmable via ISP
• 6-clock/12-clock mode programmable on-the-fly by SFR bit
• Peripherals (PCA, timers, UART) may use either 6/12-clock
• Speed up to 20 MHz with 6-clock cycles per machine cycle
• Pin to pin study of microcontroller unit
• Indicators for data, status and control pins
• Test points available for testing
• Extention conectors for connecting external circuits
• Fully static operation
• RAM expandable externally to 64 kbytes
• Four interrupt priority levels
• Seven interrupt sources
• Four 8-bit I/O ports
• Full-duplex enhanced UART

• Framing erro detection
• Automatic address recognition
• Power control modes

• Clock can be stopped and resumed
• Idle mode
• Power down mode
• Programmable clock-out pin
• Second DPTR register
• Asynchronous port reset
• Low EMI (inhibit ALE)
• Programmable Counter Array (PCA)

• PWM
• Capture/compare
• Assembler / 'C' compiler available